BACK TO HOME PAGE
Usually we have a turn key engine built & dyno tested in 6-8 weeks excluding parts back-orders.
Long Blocks usually take 3-4 weeks excluding parts back-orders.
Short Blocks usually take 2-3 weeks excluding parts back-orders.
How long does the engine build & dyno process take?
February 14, 2012 By
How Long Is Warranty?
February 14, 2012 By
Any Special Maintenance Issues On High Performance Engines
February 14, 2012 By
Some high horsepower performance engines require extra attention. They are not like your normal daily driver engines. These engines are built with high quality parts but they are under much more stress when producing the horsepower they do.
Oil & filter should be changed every 2500 miles.
Valve lash should be set every 2500 miles.
On solid lift applications the valve springs and lifters should be removed and checked every 7500 miles
This is very critical on solid roller lift applications and failure to do so could result in serious engine damage.
On Solid Roller applications try to avoid log periods of engine idle.
Whats the Benifit to Engine Balancing?
May 17, 2011 By
What is Align Hone Block?
May 16, 2011 By
Ever wondered what “Align Hone ” block means. This is where the main bearings are, and where the crankshaft sits in the block. Each engine has a specific size that these holes need to be When they are out of size, each main cap is cut, making the hole then smaller. A long honing mandrel with pressure is used to hone these holes back out round to the OEM size. If these hole size aren’t correct, then the oil clearance isn’t correct, and there will be engine damage.
